Archive

Pharmaceutical manufacturer uses this large tray to mix biochemicals

18 Feb Pharmaceutical Processing Machine

This machine was fabricated from 316 Stainless steel and will end up in a Class 1 clean room. Due to the extremely high sanitation level, we used Electro Polishing to finish the machine after fabrication....

Read More
Automation Equipment, Automotive, A2 Tool Steel, PS95 CNC Milled in multiple setups, Long relief cutters to cut pockets, low volume

17 Nov Deep Cuts, Many Setups

This is another Automation low volume part for the Automotive industry. Milled from A2 Tool Steel on our PS95, this part required long relief cutters to cut the deep pockets and several setups....

Read More
Automation Equipment, Automotive, Mild Steel, Machined on the PS95 using 7 setups, low volume

17 Nov Complex Part

This low volume item took 7 setups to machine on our PS95. It'll be used in manufacturing for the Automotive industry and was cut out of Mild Steel....

Read More
Tooling clip for Automation Equipment, Automotive 4140 PH, machined on the PS95 CNC Mill using 5 setups, high volume

17 Nov Tooling Clip for Manufacturing

This tooling clip for the Automotive industry was machined on our PS95 CNC Mill out of 4140 PH. It was a high volume part that required 5 setups per part....

Read More
Automation Equipment, Automotive, Micarta G10 high-heat resistant grade plastic, Machined on the Hurco in 6 setups, low volume, intersecting holes all have to line up

17 Nov Tricky Plastic with Precise Holes

This very small part will be used in manufacturing for an Automotive customers. Since air needs to pass through the canals within, all the holes had to line up precisely, which was difficult because the Micarta G10 high-heat resistant grade plastic tends to crack and chip easily....

Read More
Oil & Gas Equipment, Hot Rolled Steel, Welded then post-machined in three setups on the Hurco

17 Nov Welded Part with Post-Machining

An Oil & Gas Equipment manufacturer commissioned this Hot Rolled Steel part. We created the welds first, then post-machined it using three setups on the Hurco VMI 20....

Read More
Oil & Gas, First setup on Okuma CNC Lathe, second setup on the Hurco, 1018 Mild Steel, Electroless Nickel Plated

17 Nov Electroless Nickel Plated Part

This piece required two setups, one on our Okuma CNC Lathe, then one on our Hurco VMI 20. It was milled out of 1018 Mild Steel and plated with Electroless Nickel....

Read More

Ready to get started? REQUEST A QUOTE