17 Nov Mild Steel Part for Aerospace Manufacturing
Posted at 17:17h
in
This part will aid in the manufacturing of a rocket...
Archive
17 Nov Deep Cuts, Many Setups
Posted at 17:11h
in
This is another Automation low volume part for the Automotive industry. Milled from A2 Tool Steel on our PS95, this part required long relief cutters to cut the deep pockets and several setups....
17 Nov Complex Part
Posted at 17:04h
in
This low volume item took 7 setups to machine on our PS95. It'll be used in manufacturing for the Automotive industry and was cut out of Mild Steel....
17 Nov Tooling Clip for Manufacturing
Posted at 16:59h
in
This tooling clip for the Automotive industry was machined on our PS95 CNC Mill out of 4140 PH. It was a high volume part that required 5 setups per part....
17 Nov Tricky Plastic with Precise Holes
Posted at 16:56h
in
This very small part will be used in manufacturing for an Automotive customers. Since air needs to pass through the canals within, all the holes had to line up precisely, which was difficult because the Micarta G10 high-heat resistant grade plastic tends to crack and chip easily....
17 Nov Grid Template for Manufacturing
Posted at 16:51h
in
This aluminum plate was milled in 2 setups on our PS95 CNC machine for an Automotive customer to use in manufacturing....
17 Nov MIC-6 Cast Aluminum Plate
Posted at 15:47h
in
Using our PS95 CNC Mill, this cast aluminum plate was machined in two setups and anodized with a shiny metallic finish. It was a low volume part for the Automation Equipment industry....
17 Nov Color Coded Base Plates
Posted at 15:04h
in
An Automation Equipment customer had us make these low volume base plates out of 6061 Aluminum. Each required 2 setups on our PS95 CNC Mill. The customer requested an anodized finish in bright colors to match the color coding on their manufacturing floor....
17 Nov Tiny Micarta Part for Glass Handling
Posted at 14:53h
in
This little part was made out of a composite material called Micarta so it could be used in Automation Equipment without scratching up the glass it would be handling. We manufactured high volumes of the part using a single setup on our Okuma CNC Lathe....
16 Nov Tiny Part for Aerospace Manufacturing
Posted at 16:59h
in
This part was machined in 3 steps using micro carbide tooling on our Hurco VMI 20 out of 4140 PH. It was a low volume part machined for use in an Aerospace manufacturing process....
- 1
- 2